Non-Slip Coating - Traction-N-More Epoxy Master Kit
- Non-Slip Coating : TZ-20-22-M-6-B2
- Calculated at Checkout
- Product Label:
Bulk discount rates
Below are the available bulk discount rates for each individual item when you purchase a certain amount
|Buy 5 - 9||and get 4% off|
|Buy 10 - 19||and get 8% off|
|Buy 20 or above||and get 10% off|
Non-Slip Coating - Traction-N-More Epoxy Master Kit - The ultimate in slip proof protection & chemical resistance. A 6 gallon pail containing epoxy resin, hardener and aggregate for the strongest possible bond and skid proofing on concrete, metal, fiberglass and more (just not tile).
To apply: Simply clean surface, mix up 2 part paint, roll down, broadcast the aggregate over it in a uniform fashion and let it dry 24 hours for foot traffic and 48 hours for vehicular. This 100% Epoxy Non Slip coating Kit can be used to help prevent accidents on sidewalks, ramps, trucks, production areas, driveways, basement floors, bricks and stones, steps and more non slip applications. Excellent for use on floor areas which are subjected to abrasive traffic, impact and/or corrosive spillage. Easy to apply, yet tough enough to stand up to heavy vehicular traffic - even fork lift trucks.
This permanent non skid coating with its powerful industrial sand paper like finish saves down time by reducing slippery areas in any work environment even if wet or covered in liquids. (Epoxy Non Slip Coatings are Available in a variety of colors as well as custom matched floor colors as close as possible.) Low odor and easy to clean for use indoors and outdoors on sidewalks, decks, walkways, floors, concrete, steel/metal ramps, equipment and much more. ***Just a note-Please make sure "you want it where you apply it" as it is extremely difficult to remove once it dries.
• One Master Kit Covers Up To 600 Square Feet Depending on the Porosity of the Surface Being Treated.
• Available in Standard and Custom Colors
Easy To Apply:
Start with a clean, dry surface. Mix up the 2 part (Part A, Part B) non-slip paint in its entirety. Use a paddle attachment on a corded drill and mix for 5 minutes or better, let stand 10 minutes and roll onto surface. (Medium knap roller recommended) The aggregate can then be broadcast over the freshly painted area.
This will vary on temperature and relative humidity. 24 Hours for Foot Traffic. 48 Hours for Vehicular Traffic.
NOT FOR SALE IN CALIFORNIA
Epoxy Non Slip Coating - Concrete Floor Anti-Slip
Every warehouse and facility can take advantage of the Safety Enhancements that a Non-Slip Epoxy Floor Coating can do almost immediately. Available in an epoxy broadcast nonslip coating kit, Traction-N-More which comes in Master Kit (TZ-20-22-M-6) sizes that cover up to 600 ft.² and also and half size kits. This non-slip coating is available in a variety of colors and will also match custom color chips.
Traction and More provides excellent non-slip resistance on floors, ramps, especially on concrete where the epoxy can penetrate into the pores of the existing surface and provide a permanent molecular bond. This nonslip coating will also seal off any area that you apply it to. To use it simply mix the A and B cans let stand for 30 minutes and paint it down on the surface with a roller. Follow up by broadcasting the aggregate over the area while still wet over and in a uniform fashion.
This nonslip coating leaves an industrial sandpaper type finish.
Safety Seal is a premixed Anti-slip coating product that comes in a 5 gallon pail which will cover up to 1200 ft.² on inside and concrete areas. Safety Seal non-slip coating provides excellent slip resistance.
Interstate products continues to provide nonslip solutions to industry, government facilities as well as residential and contractor applications. Both products are available by special order in a pedestrian grade grit which has a lower profile grit for barefoot areas or livestock.